Offset Stack - Sharp AR-287 Operation Manual

FINISHER (AR-FN1N)

Offset stack

OUTPUT
TOP TRAY
OFFSET
TRAY
OFFSET
AUTO
3
2
1
3
2
1
7-4
In the initial setting, the offset tray will move from side to side so that
each copy set is offset by approximately 1.2 inch (30 mm).
When the offset stack function is disabled, the offset tray will not
move from side to side.
The offset stack function can be enabled or disabled by pressing the
SO OUTPUT key and then the "OFFSET" check mark box on the touch
panel.
When the STAPLE SORT mode is selected, the offset stack function
will be disabled.
AUTO 8
The top tray cannot be used to offset copies.
To select the top tray, press the "TOP TRAY" key on the touch panel.
OFFSET mode
When copying in the SORT mode, each collated set of
copies will be stacked offset approximately 1.2 inch (30
mm) from the previous set. When copying in the GROUP
mode, copies will be offset stacked in groups of multiple
copies from the same original.
NON-OFFSET mode
All copies will be aligned in one stack in the offset tray or
the top tray with no offset.