Output Trays; Offset Function - Sharp AR-235 Operation Manual

To enable rotation copy, highlight "ROTATION COPY" and press the OK
key to display a check mark in the check box.
To disable this mode, select this program and press the OK key again to
clear the check mark in the check box.
Sort Auto Select
If this program is set, the default output mode for copying from an SPF or RSPF is the sort mode. If this
program is cancelled, the default output mode will be the non-sort mode.
To enable sort auto selection, highlight "SORT AUTO SELECT" and press
the OK key to display a check mark in the check box.
To disable this selection, select this program and press the OK key again
to clear the check mark in the check box.

Output Trays

If a job separator tray kit or a finisher is installed along with a printer expansion kit or a facsimile
expansion kit, this program can be used to specify which output tray will be used to receive copies and
which will be used to receive prints.
When "OUTPUT TRAYS" is selected and the OK key is pressed, the following display will appear.
(Example: The following display is shown for a copier equipped with a printer expansion kit, a facsimile
expansion kit, and a job separator tray kit.)
1. Use the and
2. Press the OK key.

Offset Function

If the offset function is enabled, each set of copies will be stacked offset from the previous set in the
sort and group modes in the centre tray of the copier or in the offset tray of a finisher. This program is
used to enable or disable the offset function for these trays respectively.
When "OFFSET FUNCTION" is selected and the OK key is pressed, the following display will appear.
OUTPUT TRAYS
FAX
COPY
PRINT
PATTERN
1
keys to select the desired pattern of output trays.
OFFSET FUNCTION
CENTRE TRAY
OFFSET TRAY
OFFSET ON
KEY OPERATOR PROGRAMS
7
129