Atis Id Setting - Furuno FM-8800D Service Manual

4.2.6 ATIS ID Setting

ATIS (Automatic Transmitter Identification System) automatically transmits at the end
of each transmission. This is monitored by authorities to keep surveillance over illegal
transmission.
When ATIS ID is set up, following menus can be set up as well.
1. INLND-WA set up by [MENU] -> MEMORY CHANNEL
2. ON/OFF set up by [MENU] -> SYSTEM -> CH MODE -> INLND
3. RIVER/RIVER&SEA set up by [MENU] -> SYSTEM -> ATIS ID -> AREA
- In case of REVER,
INLND-WA will be the only available when set up by [SYSTEM] ->
SYSTEM -> CH MODE. INTL, USA, CANADA and PRIV cannot be used.
- In case of REVER & SEA,
All set up by [SYSTEM] -> SYSTEM -> CH MODE can be set ON/OFF.
Procedure
1. Select [MENU] -> SYSTEM -> ATIS ID and press [ENT] key.
2. Select ATIS ID and press [ENT] key. Below pop-up window will appear.
ID ENTRY
ID CLEAR
AREA
3. Select ID ENTRY and press [ENT] key.
4. Input ATIS ID of the own ship and press [ENT] key.
5. Bring a cursor onto ATIS ID again and press [ENT] key. A pop-up window of the step
2 will appear.
6. Select AREA first and then, select the operation area of the own ship, RIVER or
RIVER & SEA, then press [ENT] key.
How to clear/edit registered ATIS ID
To clear ATIS ID:
As just mentioned in the second procedure above, select ID CLEAR and press
[ENT] key.
To edit ATIS ID:
Take the same procedure and select "ID ENTRY" then edit or select "ID CLEAR"
to register new ATIS ID.
4-10
4.2 ID Setting