Furuno FM-8800D Service Manual page 166
Vhf radiotelephone
Hide thumbs
Also See for FM-8800D:
- Operator's manual (137 pages) ,
- Installation manual (72 pages) ,
- Specification sheet (2 pages)
Table of Contents
Advertisement
*** FM 8800S/D preparation and transmission on the TX side ***
5. Any channel may be selected.
6. Call up the option menus. Refer to page 4-1.
- Make a jumper connection between #2 and #15 of [Printer] port
- Or, jumper connection between #25 and #26 of IF-8810
- Press [MENU] -> SYSTEM -> [ENT] -> Input the password
7. Select "TONE TEST" and press [ENT] key. Pop-up window will appear as below.
* Tone Test Menu *
POWER HI
DSC
MARK
SPACE
DOT
CARRIER
8. In the Tone Test Menu above,
for example, select "LOW" for POWER, "DSC" for DSC, and select "MARK". The
cursor is "MARK".
9. When PTT switch is ON, CH70 is transmitted. (Modulated in Mark tone)
10. Check the Mark tone frequency by FM-8800S/D on the monitor side.
MARK tone frequency: 1300 Hz
11. After taking a measurement, go back to "Tone Test Menu" and select SPACE for the
tone frequency. The cursor is "Space".
12. Check the Space tone frequency by FM-8800 S/D on the monitor side.
SPACE tone frequency: 2100 Hz
13. Turn off the power.
6-6
6.2 Measurement
Advertisement
Table of Contents
