BODY
Read all of Section B and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
B
result in severe injury or death, remove the neg-
ative (-) battery cable before proceeding.
11
8
5
4
7
Fig. 6 Seat Support Removal
1. Drill out the four rivets (1) securing the seat hinge (2)
to the seat support frame (Ref. Fig. 6).
2. Drill out the four rivets (4) that secure the seat support
to the side panels.
3. Pull back the floormat enough to access the bottom of
the seat support panel. Drill out the five rivets (6) that
secure the seat support (3) to the floor panel.
4. Drill out the six rivets (8, 9 & 10) that secure the seat
filler panels (11) to the side panels (5) and remove.
Remove the cargo filler panels (12).
Reassembly is the reverse of disassembly and requires
the use of new rivets.
Page C-10
9
10
12
1
2
6
3
Repair and Service Manual
Rear Fender Removal
Tool List
Ratchet ........................................................................1
Socket, 7/16"................................................................1
Lug Wrench..................................................................1
Wrench, 7/16" ..............................................................1
3/8" Drill .......................................................................1
3/16" Drill Bit ................................................................1
Rivet Gun .....................................................................1
Small Pry Bar ...............................................................1
Phillips Screwdriver......................................................1
Pliers ............................................................................1
Floor Jack, 1 1/2 ton ....................................................1
Jack Stands .................................................................2
Wheel Chocks..............................................................4
41
38
Fig. 7 Rear Fender Removal
Qty.
41
39
1
2