Configuration Diagrams - Agilent Technologies 85301B Configuration Manual

Configuration Diagrams

Customer:
Address:
Customer contact:
Telephone:
Sales engineer:
Telephone:
Agilent systems engineer:
Telephone:
Date:
❏ New antenna range or ❏ Upgrade of existing range
Objective:
Antenna range parameters
1
Select either far- or near-field range
❏ Far-field antenna range
Range length:_________meters
Range type: (check one)
❏ Outdoor (elevated)
❏ Outdoor (ground reflection)
❏ Indoor (rectangular)
❏ Indoor CATR
Manufacturer:________________
Model number:_______________
❏ Other:_______________________
Range transfer function* (P
Low frequency_____-dB
High frequency_____-dB
Test channel received power*
(Boresight)
P (TEST) = P + P
r t r
P (TEST) = _____-dBm
r
Measurement sensitivity
9
Test channel received power =
P (TEST) =
r
10
Dynamic range = D =
11
Signal-to-noise ratio
(accuracy) = S/N =
12
Required measurement sensitivity =
P (TEST) - [D+S/N]=
r
* Only for far-field antenna ranges; not required for near-
field ranges.
Figure 16. General antenna range information and system parameter calculation table
❏ Near-field antenna range
Scan surface size:_____________
Range type: (check one)
❏ Planar near-field
❏ Cylindrical near-field
❏ Spherical near-field
❏ Combination of planar, cylindrical
or spherical near-field
❏ Type is unknown
/P
r t)
8
9
/P + G (AUT)
t
_____dBm
_____dBm
_____dBm
_____dBm
FAX:
Location:
FAX:
Location:
FAX:
Connector information
System component
e.g., N (f), SMA (m), etc.)
Transmit antenna
Antenna-under-test
Reference antenna (if used)
Rotary joint both ends (if used)
Bulkhead feedthrough
Other
Existing equipment
Miscellaneous
(any equipment to be used that already
exists; e.g., amplifiers, enclosures, etc.)
__________________________________________
__________________________________________
__________________________________________
__________________________________________
__________________________________________
__________________________________________
20 24
Connector type
29