True TI1000 Owner's Manual page 42

CHAPTER 6: ADDITIONAL INFORMATION
Fault SC02: Incline Stall
Fault SC03: Incline Run
Fault
Fault SC04: Motor
Under Speed
Fault SC05: Motor Over
Speed
Fault SC06: Motor
Acceleration Fault
Fault SC07: Speed
Sensor Fault
Smart
Incline Stall
Card
Smart
Incline Runaway
Card
Smart
Underspeed
Card
Smart
Overspeed
Card
Smart Excessive
Card Acceleration
Smart
No Speed Card
Card
Truefitness.com / 800.426.6570 / 636.272.7100
Console displays Fault
Calibration not saved.
Incline disabled.
Incline Potentiometer value
out of range
Acme Nut Jammed
Motor Bearings
Console displays Fault
Calibration not saved.
Incline disabled.
Incline Potentiometer value
out of range
Acme Nut Jammed
Motor Bearings
High Belt Deck Friction
High belt tension
Low Line Voltage
Dirty or misaligned speed
sensor
High Belt Deck Friction
Line Voltage
Dirty or misaligned speed
sensor
User is holding belt back
High Belt Deck Friction
Dirty or misaligned speed
sensor
Dirty or misaligned speed
sensor
High Belt Deck Friction
Low Line Voltage
Power cycle
Check cable connections
Run incline calibration
Contact dealer or TRUE service
Power cycle
Check cable connections
Run incline calibration
Contact dealer or TRUE
service
Lubricate treadbelt
Contact dealer or TRUE
service
Check drive belt and walking
belt tension
Check AC line voltage
Contact dealer or TRUE
service
Lubricate treadbelt
Contact dealer or TRUE
service
Check AC line voltage
Contact dealer or TRUE
service
Do not try to stop belt
Lubricate treadbelt
Contact dealer or TRUE
service
Contact dealer or TRUE
service
Lubricate treadbelt
Contact dealer or TRUE
service
Check AC line voltage
42 of 50