True TI1000 Owner's Manual page 37

CHAPTER 6: ADDITIONAL INFORMATION
Fault CN03:
Console
Stuck Key
Fault CN04:
Lower Board
Comm Fault Console
(Treadmill
Only)
Fault CN05:
No Lower Console
Control
Fault CN06:
Config Console
Mismatch
Fault CN07:
Calibration Console
Timeout
Fault CN08:
Calibration
Failed - Console
Lower Limit
Not Reached
Fault CN09:
Insert Safety Console
Key
Fault CN10:
Console
E-Stop Fault
Fault CN24:
BB Comm Console
Fault
Fault CN25:
Firmware Console
Mismatch
Membrane Key stuck
down/closed
Brainboard fails
to receive timely
communication
responses from lower
board - Fault after 3
retries
No lower board
connected to console
- detection wires not
connected.
Console is configured
for a product different
than that to which it is
connected.
Incline Calibration was
not able to complete
within allowed time.
During incline
calibration, the incline
stalled before reaching
what should be the
lower limit.
Emergency Circuit
opened
A test of the emergency
circuit has failed
SBC cannot
communicate with
Brainboard
Firmware on brainboard
not compatible with
SBC software
Truefitness.com / 800.426.6570 / 636.272.7100
Membrane key is
damaged
Loose Cable
Smart Card
MCB
Console
Loose Cable
Console Configure
Incorrectly
Console Configure
incorrectly
Loose Cable
Low AC Line Voltage
Console displays Fault
Calibration not saved.
Incline disabled.
Incline Potentiometer
value out of range
Safety Key not engaged
Loose Cable
Switch Damaged
Console Catch
Safety Key not engaged
Loose Cable
Switch Damaged
Console
Corrupt software
Firmware and software
versions are not
compatible
Contact dealer or TRUE service
Power cycle
Check cable connections
Contact dealer or TRUE service
Power cycle
Check Cable Connection
Re-configure console
Power cycle
Re-configure console
Check cable connections
Retry calibration
Verify AC Voltage at Outlet
Power cycle
Check cable connections
Run incline calibration
Contact dealer or TRUE service
Re-insert safety key
Check cable connections
Contact dealer or TRUE service
Power cycle
Reinsert safety key
Check cable connections
Contact dealer or TRUE service
Power cycle
Contact dealer or TRUE service
Power cycle
Reconfigure Console
Re-install software/firmware
Contact dealer or TRUE service
37 of 50