ENERGY SAVER
During normal operation, the thermostat automatically controls cooling and the fan runs
continuously. When the ENERGY SAVER is selected, the thermostat automatically
controls cooling and the fan automatically stops when the compressor is not operating.
(Fan will stop 30 seconds after the compressor stops.
rotate for 2 minutes, every maximum 20 minutes, to detect room temperature.
Procedure
During cooling operation
1
Touch ENERGY
SAVER pad.
2
To cancel, touch
ENERGY SAVER
pad again.
NOTE: ENERGY SAVER cannot be set during FAN ONLY mode operation.
TO CHANGE AIR FLOW DIRECTION
Adjust the louvers to change the direction
of air flow for uniform and efficient cooling
of the room.
EXHAUST
If air in your room is stale, set the
EXHAUST lever to the OPEN position.
This will exhaust stale air to the outside.
The EXHAUST lever should normally
be kept in the CLOSED position during
cooling for maximum efficiency.
Even after the fan stops, the fan will
Display / Indicator
Pad
• ENERGY SAVER indicator
ENERGY
SAVER
• ENERGY SAVER indicator
ENERGY
SAVER
Horizontal louvers
Adjusts UP/DOWN air flow
CLOSED
HOW TO OPERATE
)
will light.
will go off.
Vertical louvers
Adjusts LEFT/RIGHT air flow
EXHAUST Lever
OPEN
13