Preparing For In-Ceiling Or On-Surface Cable Routing - Bosch FLEXIDOME IP starlight 8000i Installation Manual

FLEXIDOME IP starlight 8000i
1.
Steps
1.
2.
3.
4.
5.
6.
7.
Fixing the surface mounting plate is finished.
Vandal-proof installation according to IK10 standard
To maintain the IK10+ rating of the installation, screws or anchors used must meet the
following specifications:
–
–
–
4.2.2

Preparing for in-ceiling or on-surface cable routing

The surface mounting plate in its delivery state can be used for in-ceiling cable routing without
further configuration.
To prepare for connecting to the camera base: Use the hooks on the surface mounting plate to
secure the cable and to form a service loop. Note: excessive cable lengths (> 30 cm) will not
fit into the confined space between camera base and surface mounting plate.
Bosch Security Systems
For on-ceiling cable routing, the cable conduit must be oriented towards the cable duct.
Use the mounting plate to mark the bore holes on the surface. Note: With in-ceiling cable
routing, make sure to have the plate centered over the cable outlet. The cable will be
passed through the center hole. The cabling must not get stuck between the surface and
the plate!
Drill four holes. Choose the right holes combination for your application.
Place your wall plugs or anchors.
For in-ceiling cabling only: pass the cable through the center hole of the surface mounting
plate.
Place the plate onto the bore holes. Make sure to proper align to the correct holes on the
plate.
Fasten the screws or studs. Torque for fastening must exceed 4 NM and shall not exceed
7 NM.
Check for firm hold of the plate.
Use no less than 4 screws or studs.
Only use the appropriate holes. Do not use the long slots in the plate for mounting.
Use 5mm screws and wall plugs or M5 anchor bolts only.
Installation Manual
Hardware Installation | en
(Preliminary picture)
17
2018.11 | 01 |