Installing An In-Ceiling Camera In A Suspended Ceiling; Tools Required; Installation Requirements; Preparing The Suspension Ceiling For Installation - Bosch AUTODOME IP 4000i Installation Manual

20 en | Installing an In-ceiling Camera in a Suspended Ceiling
9

Installing an In-ceiling Camera in a Suspended Ceiling

9.1

Tools Required

–
–
9.2

Installation Requirements

–
–
9.3

Preparing the Suspension Ceiling for Installation

You must use the VGA-IC-SP In-ceiling Support Kit to install the camera In-ceiling housing into
a suspended or drop ceiling. This kit requires a separate purchase.
1.
2.
3.
4.
5.
Figure 9.1: Suspension Ceiling Bracket (Top View)
1
2
1.
2017.08 | 1.0 | F.01U.xxx.xxx
Appropriate screwdriver (Phillips head)
Appropriate tool for cutting a hole in drywall or ceiling tile (if applicable)
The ceiling thickness ranges from 10 - 40 mm.
The ceiling can sustain at least eight (8) times the weight of the camera (1.81 kg (4 lb)): >
14.5 kg (32 lb).
Choose the desired location to mount the camera.
Remove an adjacent ceiling tile.
Loosen the four (4) securing screws, located in the corners of the Bracket Assembly,
enough to hold the suspension bars but still allowing adjustment during installation.
Place the Bracket Assembly over the ceiling tile, which is used to mount the camera.
Snap the Bar Clips of the bracket to the ceiling rails.
A
Suspension Bars 3
Base Plate 4
Use the bracket Base Plate as a template or cut a hole-sized hole in the center of the
ceiling tile with a drywall utility saw or jig saw.
Securing Screw (4)
Bar Clips
Installation Manual
AUTODOME IP 4000i
Bosch Security Systems