Motor Cables And Accessory Kits - Allen-Bradley MP-Series Installation Instructions Manual

20 MP-Series Low-inertia Servo Motor with 215 mm or Larger Frame Size

Motor Cables and Accessory Kits

This section describes accessories that are available for MP-Series low-inertia motors.
Motor Cables
Factory manufactured feedback and power cables are available in standard cable lengths. They
provide the sealing needed to achieve environmental ratings and shield termination.
For a complete listing of available cables, contact your nearest Rockwell Automation sales office
or refer to the Kinetix Motion Accessories Specifications Technical Data, publication
GMC-TD004.
Shaft Seal Kits
Shaft seals must be lubricated. Lubricant is supplied with the shaft seal kits.
IMPORTANT
Third-party shaft seals are not approved for use with these motors. The use of third-party shaft
seals voids any implied or expressed warranties.
A shaft seal is a barrier that can prevent moisture and particles from entering the motor bearings.
Shaft seals are subject to wear and require periodic inspection and replacement. Replacement is
recommended every 3 months, not to exceed 12 months, depending on use.
Catalog numbers for the motors and corresponding replacement Nitrile shaft seal kits are listed
in the table.
Motor Cat. No.
MPL-B640, MPL-B660, MPL-B680
MPL-B860, MPL-B880
MPL-B960, MPL-B980
For instructions on how to install a shaft seal, refer to the Shaft Seal Kit Installation Instructions,
publication 2090-IN012.
Rockwell Automation Publication MP-IN002E-EN-P - January 2015
Shaft Seal Kit Cat. No.
MPL-SST-A6B6
MPL-SST-A8B8
MPL-SST-A9B9