Using The "Quick-Stop" Feature; User Programmable Run Time / Run Time Extension - Code Alarm PROFESSIONAL SERIES Owner's Manual

Using the "Quick-stop" Feature

If you want to make a short stop and keep your vehicle running (to keep the interior
warm or cool), the quick-stop feature allows you to do this while keeping your vehicle
secure and your keys with you.
To engage Quick Stop:
1. Stop the vehicle and place the transmission in PARK.
2. With your foot off the brake pedal, press and release the
times within 2 seconds. The LED will flash 3 times to confirm quick
stop is entered.
3. Remove the keys from the ignition and exit the vehicle. Press the
button to lock the vehicle's doors if desired. (Using the vehicle's factory
remote)
Note: Do not leave children or animals unattended in the vehicle when using the
quick-stop feature.

User Programmable Run Time / Run Time Extension

The system has the ability to allow the user to extend the time the vehicle will be
running under control of the remote start. This will only extend the run time back to
the current run time setting during the current remote start cycle. If your system is
set to run 15 minutes and the time remaining is 4 minutes, extending the run time
will reset the countdown timer to 15 minutes and your vehicle will continue to run for
another 15 minutes. Follow the steps below to extend the vehicle's run time.
1. The remote start must already be active.
2. Press and release the
3. The system will chirp 1 time and flash the parking lights 4 times to
confirm that the run time has been reset.
4
button 4 times.
2018 Voxx Electronics Corporation. All rights reserved.
button 2