Pppoe (Stateful) - Gemtek WRTB-283N User Manual

Select PPPoE from the drop-down menu.
My IPv6 Connection:
Enter the PPPoE account settings supplied by your Internet provider (ISP).
PPPoE:
Select Static if your ISP assigned you the IP address, subnet mask, gateway,
Address Mode:
and DNS server addresses. In most cases, select Dynamic.
Enter the IP address (Static PPPoE only).
IP Address:
Enter your PPPoE user name.
User Name:
Password: Enter your PPPoE password and then retype the password in the next box.
Service Name: Enter the ISP Service Name (optional).
Select either Always-on, On-Demand, or Manual.
Reconnection Mode:
Enter a maximum idle time during which the Internet connection is
Maximum Idle Time:
maintained during inactivity. To disable this feature, enable Auto-reconnect.
MTU: Maximum Transmission Unit - you may need to change the MTU for optimal
performance with your specific ISP. 1492 is the default MTU.
Select either Obtain DNS server address automatically or Use
IPv6 DNS Settings:
the
following DNS Address.
Primary/Secondary DNS Enter the primary and secondary DNS server addresses.
Address:
Enter the LAN (local) IPv6 address for the router.
LAN IPv6 Address:
LAN Link-Local Address: Displays the Router's LAN Link-Local Address.
Enable Autoconfiguration: Check to enable the Autoconfiguration feature.

PPPoE (Stateful)