Table of Contents
Advertisement
Choose PPPoE (Point to Point Protocol over Ethernet) if your ISP uses a PPPoE connection. Your ISP will provide you with a username
and password.
This option is typically used for DSL services. Make sure to remove your PPPoE software from your computer. The software is no longer needed and
will not work through a router.
Select PPPoE(Username/Password) from the drop-down menu.
My Internet
Connection:
Select Static
Address Mode:
DNS server addresses. In most cases, select Dynamic.
gateway, and
Enter the IP address (Static PPPoE only).
IP Address:
Enter your PPPoE user name.
User Name:
Password: Enter your PPPoE password and then retype the password in
the next box.
Service Name: Enter the ISP Service Name (optional).
Select either Always-on, On-Demand, or Manual.
Reconnection Mode:
Enter the Primary and Secondary DNS Server Addresses (Static
Maximum Idle Time:
PPPoE only).
Enter a maximum idle time during which the Internet connection is
DNS Addresses:
during inactivity. To disable this feature, enable Auto-reconnect.
maintained
Maximum Transmission Unit - you may need to change the
MTU:
MTU for optimal
performance with your specific ISP. 1492 is the default
MTU.
The default MAC Address is set to the Internet port's physical interface MAC
MAC Address:
address on the Broadband Router. It is not recommended that you change the
default MAC address unless required by your ISP. You can use the Clone Your
PC's MAC Address
MAC address of your Ethernet card.
Internet Setup
if your ISP assigned you the IP address, subnet mask,
button to replace the Internet port's MAC address with the
PPPoE (DSL)
Advertisement
Table of Contents
