Dhcp Server Settings - Gemtek WRTB-283N User Manual

DHCP stands for Dynamic Host Control Protocol. The WRTB-283N has a built-in DHCP server. The DHCP Server will
automatically assign an IP address
to the computers on the LAN/private network. Be sure to set your computers to be DHCP clients by setting their TCP/IP settings to "Obtain
an IP
Address Automatically." When you turn your computers on, they will automatically load the proper TCP/IP settings provided by the WRTB-
283N. The
DHCP Server will automatically allocate an unused IP address from the IP address pool to the requesting computer. You must specify the
starting
and ending address of the IP address pool.
Enable DHCP Check this box to enable the DHCP server on your router. Uncheck
Server: to disable this function.
Enter the starting and ending IP addresses for the DHCP
DHCP IP Address
server's
Range: IP assignment.
Note: If you statically (manually) assign IP addresses
to your
computers or devices, make sure the IP addresses are
outside of this
range or you may have an IP conflict.
The length of time for the IP address lease. Enter the Lease time
DHCP Lease Time:
in minutes.

DHCP Server Settings