Mounting The Ic-3173 (Ip67) - National Instruments IC-317 Series User Manual

4. After booting the controller into safe mode, hold the RESET button again for 5 seconds to
enable IP reset, which resets the network adapter to its default configuration.
5. Reattach the reset screw using a recommended torque range of 2 Nm - 3 Nm with the
gasket in place. These values are recommended average values only. Variations in local
conditions may require deviations from these recommended values.
Safe Mode
When you boot the IC-3173 (IP67) into safe mode, it launches only the services necessary for
updating its configuration and installing software. To resume normal operations, press the
RESET button for less than 5 seconds.
IP Reset
Use IP reset to reset the TCP/IP settings when moving the system from one subnet to another
or when the current TCP/IP settings are invalid.
When the IC-3173 (IP67) is in the IP reset state, the IP address of the network port resets to
DHCP or a link-local address. You can then set up a new network configuration for the
IC-3173 (IP67) from a development machine on the same subnet, or you can connect the
IC-3173 (IP67) directly to the development computer.
Note
By default, the target automatically attempts to connect to the network using
DHCP. If the target is unable to initiate a DHCP connection, the target connects to
the network with a link-local IP address (169.254.x.x).

Mounting the IC-3173 (IP67)

The IC-3173 (IP67) has 11 screw holes with M4x0.7 thread and 8mm depth on both sides of
the device that can be used for mounting.
Caution
performance. Refer to the IC-3173 (IP67) Specifications for temperature
specifications.
To obtain the maximum allowable ambient temperature, you must mount the IC-3173 (IP67)
vertically. The following figures provide dimensional drawings and clearance information for
the IC-3173 (IP67).
Mounting the IC-3173 (IP67) to a hot surface may result in undesirable
IC-317x User Manual | © National Instruments | 45