Software Options - National Instruments IC-317 Series User Manual

Figure 42. Clearance Requirements for the IC-3173 (IP67)

Software Options

Use the following software to develop applications with the IC-317x. Refer to the IC-317x
Getting Started Guide for information about installing software.
• NI Industrial Controller Device Drivers 15.5 or later driver software.
• One of the following options for developing machine vision applications:
– LabVIEW 2014 SP1 or later, LabVIEW Real-Time 2014 SP1 or later, the NI Vision
Development Module 2015 SP1 or later.
– NI Vision Builder for Automated Inspection (Vision Builder AI) 2015 or later.
• Software for using and reconfiguring the IC-317x FPGA. Different configurations are
referred to as hardware personalities, and are defined by bitfiles. NI Industrial Controller
Device Drivers include a reconfigurable I/O personality that you can use out of the box.
Install the following software if you need to compile a custom personality for your
application:
– LabVIEW 2014 SP1 or later and LabVIEW FPGA Module 2014 SP1 or later—You
must install the LabVIEW FPGA Module to reconfigure the default personality of
the IC-317x FPGA.
48 | ni.com | IC-317x User Manual
2 in (50.8 mm)
PoE 1
SYNC
SS
PoE 3
DP
DIGITAL I/O
SS
POWER STATUS
IC-3173
SYS PWR IN
9-30V
IP67 Industrial Controller
150W MAX
RESET
2 in
(50.8 mm)
PoE 2
PoE 4
CONNECTOR 0
CONNECTOR 1
CONNECTOR 2
ISO PWR IN
5-24V