Siemens RF180C Operating Instructions Manual page 10

Description
Potential
Ungrounded installation of the system is possible with the RF180C. The following circuit
shows the internal relationships of the reference potentials.
Figure 2-2
Integration
The following figure shows how the RF180C with M12 connection block (7/8") is integrated in
an automation system. The push-pull connection block is integrated in the same manner as
the M12 connection block (7/8").
Controller e.g.
CPU S7-400
Figure 2-3
The RF180C is integrated into the hardware configuration by means of a GSDML file. The
RF180C can then be configured using HW Config of the SIMATIC manager or another
PROFINET tool. You will find the GSDML file on the "RFID Systems Software &
Documentation (http://support.automation.siemens.com/WW/view/en/65102624)" DVD.
10
Galvanic isolation of RF180C
X1
X2
PROFINET
24 VDC
to other
PROFINET nodes
RF180C configurator with M12 connection block (7/8")
Reader
RF180C
Operating Instructions, 12/2012, J31069-D0177-U001-A6-7618
Transponder
RF180C communication module