Gree GVH24AK-K3DNC8A Service Manual page 21

13
QUIET button
Press this button can turn on or turn off QUIET function.
This function is not available for this unit.
14
LIGHT button
Press this button to turn off display light on indoor unit. Press this button again to turn on display light.
15
TIMER button
At ON status, press this button once can set TIMER OFF. The character of HOUR
decrease half an hour. When holding "
Cancel TIMER OFF: Press "TIMER" button again under TIMER OFF status.
At OFF status, press this button once can set TIMER ON. Please refer to TIMER off for detailed operation.
Cancel TIMER ON: Press "TIMER" button again under TIMER ON status.
Note:
Time setting range: 0.5-24 hours.
Time interval between two operations can't exceed 5s. Otherwise, remote controller will exit the setting status automatically.
Function introduction for combination buttons
Child lock function
Press "▲" and " " simultaneously to turn on or turn off child lock function. When
on remote controller. If you operate the remote controller, the "
Temperature display switchover function
Under OFF status, press "
Operation guide
1.
After putting through the power, press "ON/OFF" button on remote controller to turn on the air conditioner.
2.
Press "MODE" button to select your required mode: AUTO, COOL, DRY, FAN, HEAT.
3.
Press "▲" or " " button to set your required temperature. (Temperature can't be adjusted under auto mode).
4.
Press "FAN" button to set your required fan speed: auto, low speed, medium speed, high speed, turbo speed.
5.
Press " " button to select fan blowing angle.
Replacement of batteries in remote controller
1. Lift the cover along the direction of arrow (as shown in Fig 1
2. Take out the original batteries (as shown in Fig 1
3. Place two 7# (AAA 1.5V) dry batteries, and make sure the position of "+"
polar and "-" polar is correct (as shown in Fig 2 ).
4. Reinstall the cover (as shown in Fig 2
18
TIMER ON. After each pressing of "
▲ " or " " button, 2s later, the time will change quickly until to
" and "MODE" buttons simultaneously to switch temperature display between
).
▲ " or "
child lock function is on, "
" icon will blink three times without sending signal to the unit.
).
).
▲
" button, time will increase or
" icon is displayed
and
Fig.1 Fig.2
Technical Information
Service Manual
.