H3C S9500 Series Operating Manual page 13

Operation Manual – QoS
H3C S9500 Series Routing Switches
Remove traffic policing setting
which applies IP group ACL and
link group ACL at same time
Configure traffic policing which only
applies link group ACL
Remove traffic policing setting
which only applies link group ACL
Note:
It is required that CIR is less than or equal to PIR and CBS is less than or equal to EBS.
You are recommended to configure CBS and EBS to numbers that are 100 to 150 times
of CIR.
For service processor boards, perform the following configurations in VLAN view.
Configure traffic policing which
only applies IP group ACL
Remove traffic policing setting
which only applies IP group ACL
Caution:
Before executing the traffic-limit command on a service processor board, you must
first configure traffic redirecting in Ethernet port view to redirect the packets of a
specific VLAN to the service processor board.
Before configuring traffic policing, you must first define corresponding ACLs and
configure the DSCP + Conform level-service parameters mapping table and the
Local precedence + Conform level-802.1p priority mapping table.
To do...
To do...
1-11
Use the command...
undo traffic-limit inbound ip-group
{ acl-number | acl-name } { rule rule
link-group { acl-number | acl-name } [ rule
rule ] | link-group { acl-number | acl-name }
rule rule }
traffic-limit inbound link-group
{ acl-number | acl-name } [ rule rule
[ system-index index ] ] [ tc-index index ] cir
cbs ebs [ pir ] [ conform { { remark-cos |
remark-drop-priority } * |
remark-policed-service } ] [ exceed
{ forward | drop } ]
undo traffic-limit inbound link-group
{ acl-number | acl-name } [ rule rule ]
Use the command...
traffic-limit inbound ip-group { acl-number |
acl-name } [ rule rule [ system-index index ] ]
traffic-index index ] [ conform { { remark-cos |
remark-policed-service } ] [ exceed { forward |
drop } ] slot slot-id
undo traffic-limit inbound ip-group
{ acl-number | acl-name } [ rule rule ] slot slot-id
Chapter 1 QoS Configuration