Configuring Eacl-Reflexive Acl - H3C S9500 Series Operating Manual

Operation Manual – QoS
H3C S9500 Series Routing Switches
To do...
Enter Ethernet port
view
Configure packet
redirection to
redirect the packet
on the specified port
to the service
processing board

6.2.2 Configuring EACL-reflexive ACL

Follow these steps to configure EACL-reflexive ACL:
Enter system view
Configure a time range
Enter ACL view
Define a rule
Exit ACL view
Use the command...
interface interface-type
interface-number
traffic-redirect inbound
ip-group { acl-number |
acl-name } rule rule link-group
{ acl-number | acl-name } [ rule
rule ] slot slot-id
designated-vlan vlanid
[ join-vlan ]
Or
traffic-redirect inbound
ip-group { acl-number |
acl-name } link-group
{ acl-number | acl-name } rule
rule slot slot-id
designated-vlan vlanid
[ join-vlan ]
To do...
system-view
time-range time-name
{ start-time to end-time
days-of-the-week [ from
start-time start-date ] [ to
end-time end-date ] | from
start-time start-date [ to
end-time end-date ] | to
end-time end-date }
acl { number acl-number |
name acl-name [ advanced |
basic ] } [ match-order
{ config | auto } ]
rule
quit
Use the command...
6-3
Chapter 6 EACL Configuration
Remarks
Required
Enter Ethernet port view
to configure BT rate limit
Required
"slotid" indicates the
number of the slot where
the service processing
board resides. Currently
the service processing
board does not support
multicast. You can restrict
multicast packets to be
redirected to the service
processor board by
configuring ACL.
Remarks
—
Optional
Required
Required
This ACL rule is used for
traffic redirecting on the
port.
—