Using A Ms3 With Bartsoft; Using A Usb Cable Connection - Bartington MS3 Operation Manual

• Update the drivers by clicking on Control Panel → System and Security → Jungo. Expand
Jungo:
• Click on 1-Bartington Instruments → Device Driver → Update Driver.
• Click on Browse My Computer for Driver Software.
• Click on Look in C:\Program Files\Bartington Instruments\Bartsoft\USB Driver (or
your chosen installation folder).
• Click on Update Driver.
• Click on 2-Magnetic Susceptibility Device → Device Driver → Update Driver.
• Click on Browse My Computer for Driver Software.
• Click on Look in C:\Program Files\Bartington Instruments\Bartsoft\USB Driver (or
your chosen installation folder).
• Click on Update Driver.
Check to see if Bartington Instruments and Magnetic Susceptibility Device are now working
properly with the MS3 meter connected. If this still isn't the case:
• Uninstall Bartsoft by going to Control Panel → Programs and Features and selecting the
program for un-installation. When prompted, ensure the device driver is also uninstalled.
Caution: Make sure that the MS3 meter is disconnected, before attempting to uninstall the
driver.
• After the un-install is complete, restart the computer. Download the latest version of the
software from the download page and install it.
• On completion of the installation, restart the computer for the second time.
• Connect the MS3 meter and wait for a few seconds for the operating system to load the
device drivers.
• Repeat the steps in
Note: In the event drivers do not install properly, refer to Troubleshooting.

8. Using a MS3 with Bartsoft

8.1. Using a USB Cable Connection

Open Bartsoft on the computer.
BARTINGTON INSTRUMENTS
Installed Drivers to ensure that the drivers are now working.
Page 8 of 15 OM3227/2