Connecting The Ms3 Meter; Connecting To A Computer Usb Port; Connecting To A Computer Serial Port; Connecting To A Ms2 Magnetic Susceptibility Sensor - Bartington MS3 Operation Manual

6. Connecting the MS3 Meter

6.1. Connecting to a Computer USB Port

Connect the MS3 USB cable between the computer side of the MS3 meter and the USB host port
of the computer (see Figure 1).

6.2. Connecting to a Computer Serial Port

It may be necessary to connect to the serial port of the computer. This is done by using the special
RS-232 serial cable supplied with the MS3 meter (see Figure 2). Connect the computer side of
the MS3 meter to the serial port of the computer. Ensure that the 5V mains charger supplied is
connected in the 5V inlet of the RS-232 cable provided to power the MS3.
Connection.

6.3. Connecting to a MS2 Magnetic Susceptibility Sensor

Connect the sensor side of the MS3 meter to the MS2 sensor with the TNC-TNC cable supplied.

6.4. Connecting to a MS2WFP Power Supply Unit

Connect the computer side of the MS3 meter to the MS2 port on the MS2WFP Power Supply Unit,
using the special RS-232 cable provided with the MS3 (see
Connect the computer port on the MS2WFP to the serial port of the computer, using the 9-way
RS-232 cable also supplied.

7. Device Drivers

7.1. Installed Drivers

On the computer, open Device Manager and expand Jungo to check that both drivers (Bartington
Instruments and Magnetic Susceptibility Device) exist and are working properly with the MS3
meter connected.

7.2. Driver Update and Troubleshooting

If they are not working correctly, this may be because the latest versions of the drivers have not
installed properly. In that case:
BARTINGTON INSTRUMENTS
Page 7 of 15
Using an RS-232 Cable
Using an RS-232 Cable Connection).
OM3227/2