American Time Wi-Fi Battery Analog Clock Quick Start Installation Manual

Wi-Fi Battery Analog Clocks Quick Start Installation Guide

If this is your first installation or you have questions at any time during this process, please call

American Time toll free at

Pre-Installation

1. Verify Dynamic Host Configuration Protocol (DHCP) settings.

2. Verify firewall port 123 is open for UDP data transfer.

• Contact your IT staff to verify these settings

3. Plan Analog Wi-FI Clock locations.

4. Verify the intended clock locations have good Wi-Fi coverage.

• Contact your IT staff for signal levels in your facility

• Remove the components from the box. Save the packing materials in case you need

them later.

Your package contains:

• Analog Wi-Fi clock(s)

• Quick Start Guide

• Installation and Operation Manual

800-328-8996

phone:

Please read this first!

800-328-8996

online:

140 3rd St. So.; PO Box 707, Dassel, MN 55325-0707

mail:

american-time.com

800-789-1882

fax:

Table of Contents

Do you have a question about the Wi-Fi Battery Analog Clock and is the answer not in the manual?

Page 1 Please read this first! If this is your first installation or you have questions at any time during this process, please call 800-328-8996 American Time toll free at Pre-Installation 1. Verify Dynamic Host Configuration Protocol (DHCP) settings. 2. Verify firewall port 123 is open for UDP data transfer.
Page 2 If clock was not preconfigured at American Time as recommended, please reference the Installation & Operation Manual. Verify clock hand placement Verify the clock hands are set at 12:00 by the factory (if not, stop and call 800-328-8996) Note: It is normal for the minute hand to shift ±...