Assembly Instructions; Battery Installation - Landa PGHW series Operator's Manual

Operations

Assembly Instructions

STEP 1: Attach a 5/8" water supply
hose to inlet connector. Minimum
flow should be 6 or 10 gpm
depending on model of machine.
STEP 4: Check engine and pump
oil level by removing oil dipstick,
making sure oil is on proper
indicator marking. Oil should be
visible one half way up sight glass
located at end of pump
(SAE 10W-40 non-foaming).
Battery
Installation
Due to Federal
Regulations
concerning shipment
KEEP OUT OF THE REACH OF CHILDREN. DO NOT TIP. KEEP VENT CAPS TIGHT AND LEVEL.
of corrosive chemi-
cals, batteries are not shipped with this machine.
Local purchase of battery will be the responsibility of
the owner. Automotive type 12 Volt Group 24 battery is
recommended for placement within the weather
resistant box. Follow safety and installation instructions
furnished with the battery.
10
Spray Wand
High Pressure
Hose
STEP 2: Attach wand to spray gun
using teflon tape on threads to
prevent leakage. Attach swivel
connector on discharge hose to
spray gun using teflon tape on
threads. Attach swivel connector on
high pressure hose to spray gun
using teflon tape on threads.
Engage safety latch to prevent from
triggering gun when inserting high
pressure nozzle.
STEP 5: Fill red gasoline tank. Fill
green fuel tank. Do not confuse
gasoline and fuel oil (diesel) tanks.
Keep proper fuel in proper tank.
DANGER/ POISON
SHIELD
SULFURIC
EYES
NO ACID
EXPLOSIVE
SPARKS CAN CAUSE
GASES
CAN CAUSE
FLAMES BLINDNESS OR
BLINDNESS OR INJURY SMOKING SEVERE BURNS
Landa PGHW Operator's Manual 8.916-485.0 - Y
Safety
Latch
Spray
Gun
Gasoline
Burner Fuel
Red Cable is attached to battery (+) positive terminal,
FLUSH EYES black cable is connected to battery (-) negative
IMMEDIATELY
WITH WATER
terminal.
GET
MEDICAL
HELP
FAST
Black - Negative
Terminal
STEP 3: Attach high pressure hose
to discharge nipple using quick
coupler. Lock coupler securely into
place by pulling back coupler collar
and inserting it into discharge
nipple, then pushing collar forward
to lock in place.
STEP 6: Install proper battery
making sure that the red cable is
attached to the positive terminal.
Use a 12V Group 24 battery on all
models except 4-40321 and 5-
35321E. These models use a U1
30 amp garden tractor style battery.
Red + Positive
Terminal
High
Pressure
Hose
Discharge
Nipple
Black
Red