Yangzhou Shenzhou Wind-driven Generator FD2.1-200-8L User Manual page 28

Installation & Connection
1. Wind-speed sensor installation
Install the wind-speed sensor on the supporting frame. If there is wind available, the three
cups of wind-speed sensor will run.
2. Connection of FS200 and wind-speed sensor
Insert the aviation plug of wind-speed sensor ' signal line into the aviation socket of FS200.
3. Connecting FS200 to power supply
12V power supply is applied to FS200. Connect FS200 TO 12V power supply. Special attention
paid to the anode and cathode, do not reverse them.
Check the wind-speed sensor, connection between wind-speed sensor, and correct
connection of FS200 power supply. If there is no problem concerning these aspects, you can
electrify. When FS200 are running, the present wind speed is displayed on nixie tube while the
present wind direction is displayed on liquid crystal screen.
PH3000 Operation
28