Faqs - Yangzhou Shenzhou Wind-driven Generator FD2.1-200-8L User Manual

FAQS

○ Why does not my electro-equipment work after connected to inverter?
● Check the dump energy. If the energy is not enough, the system will not operate normally; if
the energy is enough, please check the connecting wire between batteries and inverter is
correct.
○ Why can not the batteries be charged?
● Check whether or not the rotor is rolling, the generator have no output at too high or too low
wind speed. If the rotor is normal, disconnect the generator's wire from batteries and controller
(if there is an individual controller); check the output voltage of generator by a multi-meter. If
the voltage is normal please check the batteries is ok, otherwise check the wire of generator.
○ Why does not the rotor roll at a normal wind speed?
● If the output wire of generator is short, the rotor will not roll. Check the generator's wire after
disconnected from batteries.
○ How to lay down the generator?
●
(For 3KW & above 3KW)
1. Firstly we should stop the generator. Change control manner to "manual", and then hold on
the "reverse" or "turn" to make the generator turn a 90 angle with wind direction 。
2. After the blades stop rolling, shortcut three line of generator.
3. Hold on the "reverse" or "turn" to make the generator's end face to the direction of
putting.
4. Do the reverse steps of installation to put down the generator.
16