Auto Leveling - Monoprice MP10 User Manual

AUTO LEVELING

If the gap between the nozzle and the build platform is not correct, use the Auto Level
function to adjust the gap. You will want to perform Auto Leveling before using the printer
for the first time or after it is moved.
Note that the Auto Level function will determine the local offsets for each location on a
5"x5" grid. It will not set the global Z offset for the bed distance. This is set by tuning the
offset during the print or in the menu starting the auto level function. See the
OFFSET LIVE LEVEL
1. With the printer powered on and the Main Menu displayed, touch the Move button
on the Main Menu, then touch the Tune button on the Move Menu to enter the Set
Offset Menu.
2. Touch the Auto Leveling button. The printer will move the extruder to different
points and measure the distance from the nozzle to the print bed to determine the
proper local offset at each point. Note that this function only works with a metal
print bed or plate.
3. If you want to adjust the global offset, touch the CLOSE or FAR buttons. Note that
the global offset must be less than 0.
section below for details.
13
GLOBAL Z