Introduction / Signs And Symbols; Preface; Signs And Symbols; Notes Regarding These Operating Instructions - Ivoclar Vivadent Programat CS4 Operating Instructions Manual

1. Introduction / Signs and Symbols

1.1 Preface

Dear Customer
Thank you for having purchased the Programat
are in need of such a furnace for the CAD/CAM technique. The furnace enables sintering and glazing of ZrO
such as IPS e.max
designed and constructed for this purpose.
The Programat CS4 has also been designed according to the latest industry standards. However, inappropriate use may
damage the equipment and be harmful to personnel. Please observe the relevant safety instructions and read these
Operating Instructions carefully.
Enjoy working with the Programat CS4.

1.2 Signs and symbols

The signs and symbols in these Operating Instructions facilitate the finding of important points and have the following
meanings:
Symbol
1.3 Notes regarding the Operating Instructions
Apparatus:
Target group:
These Operating Instructions facilitate the correct, safe and economical use of the furnace.
Should you lose the Operating Instructions, extra copies can be ordered at a nominal fee from your local Ivoclar Vivadent
Service Center or downloaded from the Internet free of charge (www.ivoclarvivadent.com).

1.4 Notes regarding the different voltage versions

The furnace has been designed for the following voltage range:
118–240V / 50–60 Hz
No manual switch-over is required for the use of the different voltage versions. Make sure that the local power supply
complies with the voltage indicated on the rating plate before operating the furnace.
Only use the supplied original power cord. Do not use an inadequately measured replacement.

1.5 Notes on the images in the Operating Instructions

All images and illustrations in these Operating Instructions are used for exemplification and the details are not authoritative
for the construction of the furnace. They are symbols which may slightly differ from the original, e.g. due to simplification.
8
CS4. It is a sintering, glazing and crystallization furnace for dentists, who
®
ZirCAD as well as glazing and crystallization of IPS e.max CAD, for example. It has been especially
®
Note
Risks and dangers
Important information
Contraindication
Burn hazard
Risk of crushing
The Operating Instructions must be read.
Programat CS4
Dentists, dental professionals
materials
2