Epson TM-i Series Easy Setup Manual page 8

Perform settings on the printer to be copied to, using the following procedure.
1
Insert the USB memory.
2
Set roll paper in the TM-i, and turn the power on.
3
If you are using a printer that can be controlled (a TM printer connected
to a network), perform the following steps.
1. Connect the printer that can be controlled to the TM-i, set the roll paper in the TM printer,
and then turn the power on.
Printer that can be
controlled
Wired LAN printer
Wireless LAN printer
2. To reset to factory settings, press and hold the switch on the back of a printer that can be
controlled for more than 10 seconds.
4
Turn the TM-i power on. 
Settings are started automatically, and the result is printed.
5
If you are using a printer that can be controlled (a TM printer connected
to a network), print a status sheet for the TM printer.
Confirm that the settings for the TM printer have been changed successfully.
8
An ethernet cable is used to connect to the router. The TM-i is
also connected to the router.
A USB cable is used to connect to the TM-i.
Check the shape of the USB port on the back of the TM printer to
see what type of USB cable can be used.
For details on the connection procedure, etc., see the Technical Reference Guide
for the TM-i series.
While performing an easy setup, you cannot install the LAN cable wireless set (OT-
WL01). Install the LAN cable wireless set (OT-WL01) after easy setup is complete.
Connection method