LAUNCH
BST-460 Battery System Tester User Manual
●
Return key
Return to previous menu via blue RETURN key.
●
OK key
Confirm the selection via green OK key
●
MENU key
Enter additional function program via MENU key.
3.2 Tester Startup
The tester automatically starts up after the clamps are correctly
connected, and displays the Launch startup interf ace (Default
voltmeter is ON) refer to figure 1.
Figure 1, Startup Interface with Voltmeter on
By default, the voltmeter value at the middle bottom of the startup
interface can be used as DC voltmeter. The measurement range of
DC Voltmeter is 8-30DCV, out of which will damage the tester.
Voltmeter function can be set as "OPEN/CLOSE" in "Set voltmeter"
under Additional Functions.
If Voltmeter is OPEN and no activities are made on the tester after
startup, the screen will remain as the startup interface all the time. In
this case, it can be used as a DC Voltmeter. W hen OK key is pressed,
tester enters the battery test program. Press MENU key, it enters
additional function program.
When Voltmeter is OFF, the startup interface will display as figure 2.
After 2 seconds, it automatically enters the battery test program.
Press MENU key within this 2 seconds, it enters additional function
program.
6