Vibrating Element Smart40, 48, 56 And 65 - Husqvarna SMART 40 Safety And Operating Instructions Manual

Safety and operating instructions
1. Unscrew the reducer (A) from the stator tube (B)
(left hand thread). The stator is glued inside the
tube.
2. Remove the complete tube (C) including the end
cap from the stator tube (B).
3. Remove the spring washer (D).
C
4. Slide and remove the rotor (G), the excenter (E)
and the ball bearing (F).
C E
5. Unscrew the nut (H) (right hand thread), and
remove the rubber gasket (I).
6. Unscrew the nipple (J) (right hand thread).
K
7. Use a suitable rod and a mallet to gently press
the bearing holder (K) to remove the holder.
Assembly
1. Assemble the vibrating element in the reverse
order. Clean all parts before the assembly.
2. Replace the damaged parts and the O-rings
systematically.
3. Fill the vibrating element with oil. (See the section
Lubrication for information about type and
amount of oil.)
16
A D B
F G
J I H
© 2016 Construction Tools PC AB | No. 9800 1207 01d | 2016-06-21
Vibrating element SMART40,
48, 56 and 65
Disassembly
1. Unscrew the end cap (A) from the stator tube (B)
(left hand thread). The stator is glued inside the
tube.
A
2. Unscrew the nut (C) (right hand thread), and
remove the flexible sheathing (D) and the rubber
gasket (E).
3. Unscrew the nipple (F) (right hand thread).
F
4. Use a suitable rod and a mallet to gently press
the rotor (G) through the bearing holder (H). After
the removal of the bearing holder (H), remove
the eccentrics (I) and the eccentrics screws (J).
The bearing (K) can be removed after the
eccentrics have been removed.
K
Assembly
1. Assemble the vibrating element in the reverse
order. Clean all parts before the assembly.
2. Replace the damaged parts and the O-rings
systematically.
3. Fill the vibrating element with oil. (See the section
Lubrication for information about type and
amount of oil.)
NOTICE Carefully clean the threads on the end cap
and the tube before gluing with LOCTITE®638™ .
The threads must be perfectly clean and contain no
residues of oil or dust.
LOCTITE is a registered trademark of Henkel
Corporation. 638 is a trademark of Henkel
Corporation.
SMART
B
E D
J
I
G H
Original instructions
C