Download  Print this page

Vibrating Head; Connecting The Vibrating Head; Vibrating Element Smart28E - Husqvarna SMART 40 Safety And Operating Instructions Manual

Electronic pokers
Hide thumbs

Advertisement

SMART

Vibrating head

The vibrating head is maintenance free and
lubricated with oil. When replacing the vibrating head
it must be lubricated with the right amount of oil. The
end cap of the vibrating head is glued and must be
tightened and glued in the right way.
Lubrication
SMART
Vibrating head
28E
3
Shell T46 oil, cm
(cl)
10
(1)
NOTICE Before fitting a new end cap, carefully
clean the threads. Before gluing the parts together
they must be perfectly dry with no oil or grease.
1. Apply four glue strings vertically over the end cap
threads. Make sure that no glue comes inside
the tube.
2. Tighten the end cap to the specified torque.
3. Let the glue polymerize for six hours before use.
SMART
Vibrating head
Gluing
A
End cap
LOCTITE®243™
B
Reducer
LOCTITE®243™
C
Screw
LOCTITE®243™
D
End cap
LOCTITE®638™
E
Screw
-
F
Nipple
LOCTITE®243™
G
Thrust screw
LOCTITE®243™
H
Screw
LOCTITE®243™
LOCTITE®243™, LOCTITE®638™ are a registrated
trademark of Henkel Corporation. 243, 638 is a
trademark of Henkel Corporation.
A
B
© 2016 Construction Tools PC AB | No. 9800 1207 01d | 2016-06-21
Original instructions
40/
48/
56/
65
40E
48E
56E
5
10
15
20
(0.5)
(1)
(1.5)
(2)
Tightening torque, Nm
28E
40/
48/
56/
65/
40E
48E
56E
65E
75
-
-
-
-
120
-
-
-
-
-
-
-
-
-
-
170
350
520
750
-
5
8
8
20
-
120
200
250
250
-
-
-
-
-
-
-
-
-
-
C
Safety and operating instructions
D
E
NOTICE Do not grease the inner shafts too
extensively. Greasing too much can cause overload
of the electric drive unit and trip the circuit breaker.
Run the unit for two minutes continuously to distribute
the grease in the flexible shaft before immersion in
the concrete.

Connecting the vibrating head

1. Connect the ground (earth) wire on the poker
nipple. Use LOCTITE®243™ to glue the screw
on the poker.
2. Use connectors and thermo-insulation to connect
the wires to the poker stator.
3. Slide the red hose over the wires and place the
hose close to the poker gland.
4. Fix the hose on the poker nipple by using a
clamp.
5. Slide the wires inside the converter casing,
through the gland.
6. Fasten the nut and fit the hose over the converter
casing nipple and fix it with a clamp.
7. Use new connectors to connect the wires in the
converter.
8. Fit the cover to the converter.
LOCTITE®243™ is a registered trademark of Henkel
Corporation. 243 is a trademark of Henkel
Corporation.

Vibrating element SMART28E

Disassembly
E
F
G
H
15

Advertisement

Table of Contents
loading

  Also See for Husqvarna SMART 40