Introduction; General; Symbols Used; Abbreviations - Heatrae Sadia HI-MAX INSTANT ID 5-60 Installation, Operation And Maintenance Manual

1. Introduction

1.1 General

The following instructions are offered as a guide to the
user and installer.
The installation must be carried out by a competent
plumbing and electrical installer in accordance
with Building Regulations, The Building Standards
(Scotland) Regulations 1990, The Building Regulations
(Northern Ireland), UK Water Regulations and IEE
Electrical Regulations.

1.2 Symbols used

In these instructions various risk levels are employed to
draw the user's attention to particular information. In
doing so we wish to safeguard the user, avoid hazards
and guarantee the correct operation of the appliance.
DANGER
Risk of a dangerous situation causing serious
physical injury.
WARNING
Risk of dangerous situation causing slight
physical injury.
CAUTION
Risk of material damage.

Signals important information.

1.3 Abbreviations


DHW - Domestic hot water

PRV - Pressure reducing valve

Prv - Pressure relief valve

HIU - Hydraulic interface unit

PICV - Pressure independent control valve

Stv - Safety tempering valve

PID - Proportional integral derivative

1.4 Liabilities

Manufacturers liability
Our products are manufactured in compliance with the
requirements of applicable European Directives.
This appliance complies with the requirements of
the CE marking directive and is Kiwa approved to
show compliance with Water Regulations and Nemko
approved for electrical safety.
In the interest of customers we are continuously
endeavouring to make improvements in product
quality. All the specifi cations stated in this document
are therefore subject to change without notice.
Our liability as the manufacturer may not be invoked in
the following cases:

Failure to abide by the instructions on using the
appliance.

Faulty or insuffi cient maintenance of the appliance.

Failure to abide by the instructions on installing the
appliance.
Installer's liability
The installer is responsible for the installation and the
commissioning of the appliance. The installer must
respect the following instructions:

Read and follow the instructions given in the
manuals provided with the appliance.

Carry out installation in compliance with the
prevailing legislation and standards.

Perform the initial start up and carry out any checks
necessary.

Complete the commissioning checklist.

Explain the installation to the user.

If maintenance is necessary, warn the user of the
obligation to check the appliance and maintain it
in good working order.

Leave all the instruction manuals to the user.
Users liability
To guarantee optimum operation of the appliance, the
user must respect the following instructions:

Read and follow the instructions given in the
manuals provided with the appliance.

Call on qualifi ed professionals to carry out
installation and initial start up.

Ask the installer to explain the installation.

Have the required checks and services carried out
annually.

Keep the instruction manuals in good condition
and close to the appliance.
3