Intercel Smart SAM4Q User Manual page 19

Smart SAM4Q User Guide V1.1
AT$PARAMETERS?
$PARAMETERS:
APN: telstra.extranet
USERNAME: intercel
PASSWORD: mach
LTCPPORT: 10000
RTCPIP: 203.45.1.236
RTCPPORT: 10000
TCPMODE: 0
LUDPPORT: 20000
RUDPIP: 203.45.1.236
RUDPPORT: 20000
BAUDRATE: 115200
DATALEN: 8
PARITY: NONE
POLLPERIOD: 60
RESETPERIOD: 1440
SBREAKTIME: 100
MBREAKTIME: 5
SERIALLOCK: 0
LOGINTIMEOUT: 300
SESSIONIDLETIME: 120
PPPAUTH: CHAP
SAMMODE: 0
OK
AT$UDPCONNECT
If the modem is already allocated an IP address, this command will put the modem in UDP data
mode, the modem DCD pin goes high, data from serial will be packetized into UDP packets and sent
to remote UDP server (UDP settings must be set prior), modem will return to AT Command mode if
it receives no UDP data in 30 seconds.
If modem has no IP address (CSD mode or SAMMODE=2), the modem will connect to PSD and go
into UDP data mode, the modem DCD pin goes high, data from serial will be packetized into UDP
packets and sent to remote UDP server (UDP settings must be set prior), modem will reset and
return to CSD mode if it receives no UDP data in 30 seconds.
AT$TCPCONNECT
If the modem is already allocated an IP address, this command will make a TCP client connection to
the remote TCP server, the modem will return to AT Command mode if it receives no TCP ACK in 30
seconds.
17 Ver1.1