Traulsen UHT48 Service Manual page 9

V. REMOVAL & REPLACEMENT OF PARTS (cont'd)
V. f - DOOR HINGE MECHANISM (cont'd):
Remove the door spring and two plastic bushings (see
figure 12).
Remove the screws from the hinge mechanism and
remove it from the door (see figure 13).
Insert the replacement hinge mechanism into the door.
Use the hinge plate to turn hinge mechanism past the
point of being spring loaded. This will allow the stem
to be inserted into the square hole in the hinge plate.
A. For LH Hinge, Turn Clockwise.
B. For RH Hinge, Turn Counter-Clockwise.
Install the plastic bushing, the spring and the second
plastic bushing on the hinge mechanism stem. At-
tach the hinge plate to the hinge mechanism.
NOTE: The lock washer is critical and must be installed.
Install the door as outlined in section "V. e."
ILLUS.
NO. NAME OF PART
1 Mach. Screw 10-32 x
2 Hinge Plate (Lower RH,Upper LH)
3 Self-Tapping Screw
4 Pin-Upper Hinge Pivot
5 Hinge Spacer
6 Bushing - Door Stop (Short)
7 Door Handle (Does Not Include Tape)
8 Door Gasket
9 Plug Button
10 Self-Tapping Screw 8-18 x
11 Square Plug
12 Hinge-Power Cartridge Assy.
(Incls. Spring, Washers & Retaining Screw)
13 Spacer-Hinge
14 Self-Tapping Screw
15 Plate-Hinge (Lower LH,Upper RH)
16 Self-Tapping Screw 10-24 x
17 Door Assembly. (Right Hand)
18 Door Assembly. (Left Hand)
19 Tape For Door Handle
20 Traulsen Nameplate with adhesive
WARNING: UNPLUG UNIT BEFORE SERVICING
3 Truss Hd
⁄
8
1 -20 x 5 Hex Washer Hd., Type TT
⁄ ⁄
4 8
Phil Pan Hd., Type B
3
⁄
8
-20 x Hex Washer Hd., Type TT
1 5
⁄ ⁄
4 8
Phil Truss Hd., Type D
1
⁄
2
-8-