Page 1
All Traulsen units are placed on a permanent record file with the service department. In the event of any future questions you may have, please refer to the model and serial number found on the name tag affixed to the unit.
The serial tag is a permanently affixed sticker on which is recorded vital electrical and refrigeration data about your Traulsen product, as well as the model and serial number. This tag is located in the right interior compartment on all full size undercounter and equipment stand models.
Under no condition may a damaged unit be re- turned to Traulsen & Co. without first obtaining writ- ten permission (return authorization). III. INSTALLATION III.
III. d - INSTALLING LEGS OR CASTERS (cont’d): Please note that Traulsen units are not designed to be moved while on legs. If the unit requires moving, a pallet jack or forklift should be used to prevent dam- age. For installing casters, the casters are “plate”...
V. CARE & MAINTENANCE V. a - CLEANING THE CONDENSER: The most important thing you can do to insure a long, reliable service life for your Traulsen is to regularly clean the condenser coil. The condensing unit requires regularly scheduled cleaning to keep the finned condenser clean of lint and dust accummulation.
VI. a - ADJUSTING THE SHELVES (cont’d): rotating clockwise. Make sure the pin is securely tight- ened down. Do not over tighten. Slide the shelf into its new position, and replace the white plastic covers into the holes vacated by the shelf pins. VI.
Page 7
VI. MISC. OPERATIONS (cont’d) Fig. 7a Remove Louver Assembly Fig. 7b Fig. 9 Removing Power Pack...
Your new Traulsen Undercounter Refrigerator or Freezer is equipped with a state-of-the-art electronic microproces- sor INTELA-TRAUL control, which precisely regulates operation and provides alarms when problems occur. It is ® supplied from the factory completely ready for use but without the audible alarms activated. See pages 8 thru 17 for more information.
VII. INTELA-TRAUL VII. b - ALARM EXPLANATIONS: *NOTE: Explanation of alarms assume the audible alarm style is set at a 3-second burst or a continuous audible alarm. References to the audible alarm do not apply if the audible alarm style is set to OFF (Refer to page 17 for setting the audible alarm style). High Cabinet Air Temperature: The audible alarm* will sound and the display will read HI CAb when the temperature inside the cabinet rises above a pre-programmed limit.
VII. c - CONTROL PANEL: ° LED FOR 3-DIGIT (RED) LED DISPLAY VII. d - PARTS ASSEMBLY: (UC/UL Cabinets) COIL SENSOR* 337-60071-00 (refrigerator & freezer only) CABINET SENSOR* 337-60069-00 INTELA-TRAUL** HORIZONTAL CONTROLLER 337-60062-00 HOLDER CLIP DEFROST COMPRESSOR RELAY POWER LINE IN 2 VII.
VII. e - NOTES TO THE USER: You only have 20-30 seconds between button pushes. If you take longer than 30 seconds, the controller will revert back to displaying the cabinet temperature. If you enter the wrong security code, the controller will revert back to displaying the cabinet temperature.
VII. g - CUSTOMER SERVICE PARAMETERS: Listed below are the available parameters in the order they appear, using the down arrow key on the controller. You can use either the up or down arrow keys to scroll through the options. Thermostat Set Point High Thermostat Set Point Low Temperature Scale...
VII. i - ADJUSTING THE THERMOSTAT SET POINT LOW: This parameter sets the low point of the desired cabinet temperature range. Typically, freezers will range from –6° F to -4° F (-21° C to –20° C) and refrigerators will range from 32° F to 34° F ( 0° C to 1° C) for this parameter setting.
VII. k - SETTING THE 24-HOUR CLOCK: The internal timeclock must be set in order for the data storage memory to correctly log events and to allow any defrost lockout to occur at the correct time of day. If the clock is not set, the control assumes the time is 12 am at the time power is supplied to the unit.
VII. l - SETTING THE DATE: The date must be set in order for the data storage memory to correctly log events. Follow the instruc- tions to enter the customer access code on page 9. When the control displays Set Point High, press the down arrow key the set button .
INTELA-TRAUL ° ° NOTE: Traulsen refrigerator units also have an off-cycle defrost once an hour, at which time the control will read . This defrost is temperature terminated and can last from 3 - 10 minutes (dEF will be displayed for 22-27 minutes time).
VII. o - SETTING THE DEFROST LOCKOUTS: The defrost lockout parameters allow the customer to prevent the unit from going into a defrost cycle for two hours during a set timeframe. Customers can set up to four defrost lockout parameters. They are all programmed the same way.
VII. p - ADJUSTING THE ROOM TEMPERATURE OFFSET: The room temperature offset parameter allows a service technician or end user the ability to have the display show a temperature that is within three degrees of the actual temperature being read by the cabinet air sensor.
VII. INTELA-TRAUL (continued) ® VII. r - VIEWING SENSOR TEMPERATURES: These parameters allow a service technician or customer to view the temperature of all sensors within the unit. The temperatures cannot be adjusted. Follow the instructions to enter the customer access code on page 9. When the control displays Thermostat Set Point High , press the DOWN arrow key unit the display reads...
VIII. TROUBLE SHOOTING GUIDE FIND YOUR PROBLEM HERE 1. Condensing unit fails to start. 2. Condensing unit operates for prolonged periods or continuously. 3. Food compartment is too warm. 4. Food compartment is too cold. 5. Condensation on the exterior surface. 6.
TRAULSEN & CO., INC. warrants to the original purchaser the Refrigeration Equipment manufactured and sold by it to be free from defects in material and workmanship under normal use and service for a period of one (1) year from date of shipment. Under this warranty, TRAULSEN & CO., INC. will reimburse the purchaser for the replacement of any part of said equipment (excluding dryers &...
X. c - WARRANTY REGISTRATION: For your convenience, the warranties on your new Traulsen unit may be registered with us by one of two methods. Completing the enclosed warranty card (shipped with the unit), or by filling out the on-line warranty registration form located on the Technical Service page of our website (www.traulsen.com).
Need help?
Do you have a question about the UC Series and is the answer not in the manual?
Questions and answers