Condenser Fan Assembly - Traulsen UHT48 Service Manual

V. REMOVAL & REPLACEMENT OF PARTS (cont'd)
27" Models
Begin by removing the screws that secure the fan
mounting bracket and remove it from the condensing
unit shroud (see figure 28).
Pull the blade from the motor shaft.
NOTE: To replace the fan blade only, reverse the pro-
cedure to install.
Next, disconnect the lead wires from the motor and
remove the fan motor from the mounting bracket.
Reverse the procedure to install.
WARNING: UNPLUG UNIT BEFORE SERVICING
V. n- CONDENSER FAN ASSEMBLY:
-14-
48" & 60" Models
Begin by disconnecting the lead wires from the motor
(see figure 29).
Next, remove the screws that secure the fan mounting
bracket. Pull the blade from the motor shaft then re-
move the fan motor from the mounting bracket.
Reverse the procedure to install.