Bowflex MAX Trainer M7i Owner's/Assembly Manual page 47

Condition/Problem
Pedals will not move
Fan will not turn
Unit rocks/does not sit level
to operate
Rubbing sound outside of
Shrouds during operation
Metallic rubbing sound from
within Shrouds during operation
Machine seems to release
Pedals for a moment during
operation
Workout results will not sync
with Bluetooth enabled device
®
Things to Check
Check connection at front of unit Connection should be secure and undamaged. Replace adapter or connec
Check data cable integrity
Check data cable
connections/orientation
Reset machine
Pedal locations
Check for blockage of fan
Check leveler adjustment
Check surface under unit
Hardware
Caps
Brake bracket
Belt slip
Current console mode
Total time of workout
Fitness machine
Bluetooth enabled device
®
Fitness App
Assembly / Owner's Manual
Make sure unit is plugged into a functioning wall outlet.
tion at unit if either are damaged.
All wires in the cable should be intact. If any are cut or crimped, replace
cable.
Be sure cable is connected securely and oriented properly. Small latch on
connector should line up and snap into place.
Unplug unit from electrical outlet for 5 minutes. Reconnect to outlet.
Magnet should be in place on pulley.
Speed sensor should be aligned with magnet and connected to data cable.
Realign sensor if necessary. Replace if there is any damage to the sensor or
the connecting wire.
Handlebars and apply your weight to the heel of the higher foot. While still
grasping the Static Handlebar, lean back slightly applying more weight onto
the heel. Once the Pedals begin to move, resume your intended workout.
Remove material from fan. Be sure not to move the Handlebars, Legs or
Pedals.
Be aware that the Fan, Handlebars, Legs and Pedals are con-
nected and when either of these parts move the other does as
well.
If necessary, detach the Shrouds to help with removal. Do not operate ma
chine until Shrouds have been replaced.
Adjust levelers until machine is level.
Move machine to level area.
Tightly secure all hardware on the Pedal Arms and Handlebar Arms.
Slightly loosen Caps on Crank Arms
Brake bracket needs to be aligned. Contact your local distributor for further
assistance.
Contact your local distributor for further assistance.
Machine must be in Idle Mode to sync. Push the PAUSE/STOP button until
A workout must be longer than 1 minute to be saved and posted by the
Console.
Unplug unit from electrical outlet for 5 minutes. Reconnect to outlet.
Consult your device to be sure that the Bluetooth
enabled on it.
Contact your local distributor for further assistance.
47
Solution
wireless feature has been
®