Installing The Appliance - Belling GTG60 User Manual

Installing the appliance

This appliance is to be built into a worktop cutout, 600mm deep, providing the following
minimum distances are allowed;
• The edges of the hob must be a minimum distance of 65mm from rear wall and 200mm from side
wall.
• 700 mm between the highest point of the hob surface (including the pan supports) and the
underside of any horizontal surface directly above it.
• 400mm between the level of the hob and the underside of the wall units adjacent to the hob. The
area above the hob must be kept free of combustible materials for a distance of 50mm behind and
either side of the hob in the horizontal orientation up to a height of 400mm in the vertical orientation.
• 50 mm clearance around the appliance and between the hob surface and any combustible
materials.
• 45 mm You must have a gap (in the horizontal orientation) of at least 25 mm and at most 74 mm
between the underneath of the appliance and any surface that is below it (such as an isolation plate
or an oven).
With Glass hob
To prevent leakage of liquid between the frame of the hob and the worktop, place the adhesive seal
provided along the entire outer edge of the underside of the hob before assembly.
14