Belling GTG60 User Manual page 15

With Steel hob
To prevent leakage of liquid between the frame of the hob and
the worktop, put the insulating seal provided in position before
assembly.
1. Install the product into the worktop cut-out and use a pencil to
draw a line along the product outer edges.
2. Take out the product and place the adhesive seal provided
along the line you drew in step 1. Use light pressure to make
the seal stick to the worktop.
3. Install the product again, Use light pressure to make the seal
stick to product edge.
4. Carefully trim the surplus edge away from the seal.
5. Clean the edge of the hotplate and the area of the worktop
immediately adjacent to the appliance.
Do not use a silicon sealant to seal the appliance against the aperture.
This will make it difficult to remove the appliance from the aperture in
future, particularly if it needs to be serviced.
1. Remove the pan supports, burner caps and burner skirts, and turn the
hob upside down. Place the bracket (B) over the holes that match the
size of the screws. There are one set of screw holes in each corner
of the hob (H). Slightly tighten a screw (C) through the bracket (B) so
that the bracket is attached to the hob, but so that you can still rotate
the bracket.
2. Carefully turn the hob back over and then gently lower it into the
aperture hole that you have cut out.
3. On the underneath of the hob, rotate the brackets into a position that
is suitable for your worktop. Then fully tighten the screws (C) to
secure the hob in the worktop. Leave a small gap between the work-
top bracket and the underside of the worktop to allow space for heat
expansion.
15