Power Supply - WMF 5000S Service Manual

Service 18
2.8

Power supply

The same power supply is used on the WMF 5000S as for the WMF 1500S.
The power supply converts an unstabilized input voltage into a stabilized DC voltage.
The power supply can be provided with a 115 V (with a jumper on J5) and a 230 V input voltage and delivers 5 V, 24, and 30 V output voltages
Once the machine is switched on using an On switch, the outgoing invoices are made available by the power supply.
J5- Connect the jumper with an input voltage of 115V
In the event of an error, e.g. a surge current or short circuit, the power supply switches off.
->If the power supply detects more than one error, this can only be reset by disconnecting the machine from the mains for 5 minutes.