Table of Contents
Advertisement
To directly operate the module on your computer's network connection, you may have to alter
your computer's network configuration. If in doubt, contact your system administrator.
2. Connect your module with the power supply (24 V, 3 A).
3. The module will now start up. The indicator for the operating state will light up blue and after
about 5 seconds it will start flashing quickly blue. This signals that the module is booting. After
about 15 seconds the indicator will slowly flash white. The module is ready for use.
4. On your computer, open its web browser and enter the address http://192.168.1.20.
5. You will be presented with the module's configuration interface (Figure 18)
6. From the menu, select the „Motion" → "Manual Control" option and click on the „Home" button
(Figure 19). The module will now zero itself.
Figure 18: The starting page of the web-based interface
- 27 -
Advertisement
Table of Contents
