Adjusting The Headset - IBM -3345 Installation And Operation Manual

March 15, 2001
OPERATION – continued
When you first use the phone after charging or recharging the battery pack, the phone might not work and you
might hear error tones.
•
If you hear the error tones, return the remote keypad to the base for at least 5 seconds to reset the security
access-protection code.
•
Recharge the battery pack when the BATT. LOW indicator on the remote keypad lights.
•
If the battery status is on low, the battery indication is as below :
•
If the battery pack power is too low, the BATT. LOW indicator on the remote keypad will not light.
•
If the IN USE/CHARGE indicator does not light when you place the keypad in the base unit, check the
charging contacts on the remote keypad and base. If the connects are dirty or tarnished, clean them with a
pencil eraser. (See Figure 11)
•
About once a month, fully discharge the battery pack by keeping the remote keypad off the base unit until
Batt. Symbol mark appears in the LCD screen. This will maintain the battery pack's ability to fully recharge.

ADJUSTING THE HEADSET

Put on the headset, and adjust the band until it rests with almost no pressure on your ear and the top of your
head. (See Figures 12 and 13)
1. If the headset is too loose, remove it and gently push the headset band inward slightly to tighten it. If the
headset is tight, gently pull the headset band out to loosen it.
2. The microphone boom can be swiveled to position the headset on either your right or left ear.
3. Use one hand to hold the headset in place. Adjust the microphone boom until it is about 1 inch from your
mouth. Do not twist the mic on the end of the boom as this may damage the internal wiring.
4. Use the clothing the clip to attach the headset cord to your lapel or collar and out of your way.
5. Leave enough slack in the headset cord so that you can move your head freely.
6.
When you are not using the headset, always place it on the base unit headset holder.
Figure 12
IBM-3345 (REV : 0.1)
16