Wall Mounting; Headset And Data Jack; The Data Jack; The Headset Jack - IBM -3920 Installation And Operating Manual

WALL MOUNTING

The base unit and the charging cradle may be installed onto two screws (one
pair included) fastened into the wall. When installing screws into plasterboard
walls, use wall anchors (not included) to ensure that the screws remain secure.
Insert the screws into the wall, leaving 3/16" of each screw extending out from
the wall. See the wall mount templates on page 49 to properly space the
screws in the wall for mounting. The IBM-3920 is not compatible with mounting
on a wall mount telephone jack.
Handset/Cradle Wall Mounting Instructions:
1. Remove the handset from the charging cradle.
2. Adjust the charging cradle to the wall mount
position.
3. Plug the AC adapter into the jack in base of the
cradle and run the cable down through the cable
channel.
4. Slip the cradle onto the wall, lining up the wall
mounting holes over the screws. Slide the cradle
down so it is firmly in place.
5. Return the handset to the charging cradle.
6. Plug the other end of the AC adapter into the AC outlet.
Base Wall Mounting Instructions:
1. Place the bottom mounting tab on the end of the base wall
mounting plate into the lower attaching bracket on the back of
the base. Lock the plate in place with the side brackets.
2. Plug the supplied 7-foot telephone cord into the
"LINE" jack on the telephone.
3. Connect the telephone line cord to the wall jack.
4. Insert the AC adapter into the 9V DC jack on the
back of the base.
5. Slip the telephone base onto the wall, lining up the
wall mounting holes over the screws. Slide the
telephone base down so it is firmly in place.
6. Plug the other end of the AC adapter into the AC outlet.
15

HEADSET AND DATA JACK

Line Data
Data Jack

The Headset Jack

The headset jack is located on the right side
of the handset and is a standard 2.5mm plug.
Simply plug the headset into the jack and the
headset will be active.
Note: When the headset is plugged into the
telephone, the microphone and
earpiece on the handset are not active.

Belt-Clip

The belt-clip is integrated into the handset of the IBM-3920. To
utilize the clip, simply push down on the top of the clip until it
locks into place.
Belt-clip

The Data Jack

The jack located on the back of the
base labeled "DATA" is a
convenience jack. It is useful for
connecting a fax machine or
modem when there is no
telephone jack available for that
device.
Headset Jack
16