Table of Contents
Advertisement
March 15, 2001
CARE AND MAINTENANCE
REPLACING THE BATTERY PACK
Replace the remote keypad battery pack if it does not hold a charge for more than 2 hours after an overnight
charge.
1. Replace the old battery pack with a new 3.6V @600mAh metal hydride battery pack.
2. The replacement battery pack must have a connector that fits the connector pins located in the remote
keypad battery compartment.
3. An equivalent battery pack may be available at your local electronics store.
4. Replacement battery packs can be obtained directly from TT Systems Corporation. If you desire to purchase
an exact replacement battery pack, an order form can be found on the rear cover of this manual.
5. Caution: Please refer to and read the BATTERY CAUTIONARY INSTRUCTIONS found on Page of this
manual prior to replacing the battery pack.
6. Important: Your telephone contains a rechargeable metal hydride battery pack. At the end of the battery
pack's useful life, it must be recycled or disposed of properly. Contact your local, county, or state hazardous
waste management authorities for information on recycling or disposal programs in your area.
7. Install the new battery pack as described in "Installing the Battery Pack" on Page 13 and "Charging the
Battery Pack" on Page 15 of this manual.
8. Important: The new battery pack must be charged for about 15 hours before you use it the first time.
9.
The maximum standby time for a freshly charged battery pack is approximately 7 days.
The maximum talk time is approximately 6 hours.
The IBM-3345 has been designed to give years of trouble free service. To help insure its longevity,
please read the following maintenance instructions:
•
Keep the IBM-3345 dry. If it gets wet, first unplug the AC adapter then wipe the unit dry immediately. Liquids
can contain minerals that can corrode electronic circuits.
•
Use and store the IBM-3345 only in normal temperature environments. High temperatures can shorten the
life of electronic components and distort or melt its plastic parts.
•
Keep the IBM-3345 away from dust and dirt, which can cause premature product failure.
•
Handle the IBM-3345 gently and carefully. Dropping it can cause serious damage to circuitry, or plastic case,
which may result in causing it to malfunction.
•
The IBM-3345 has built-in surge protection circuits that meet or exceed FCC requirements.
However, an incident such as a lightning strike at or near the telephone lines, could cause serious damage.
•
If the IBM-3345 is installed in an area with frequent / or severe electrical storm, it is suggested that the
telephone be disconnected during these storms or that additional surge suppression equipment be added
to the installation.
•
It is the responsibility of users requiring service to report the need for service to TT Systems Corporation.
They will make the necessary arrangements for repair or replacement.
•
Should you have any questions about the operation of the IBM-3345, please call 1-914-968-2100,
between the hours of 9:00 A.M. and 4:30 P.M. eastern time. Or you may contact TT Systems Corporation
for technical assistance via our Internet Website: http:/www.tech@ttsystems.com.
IBM-3345 (REV : 0.1)
25
Advertisement
Table of Contents
