OPERATING INSTRUCTIONS
Locating a Torque Wrench
Ensure the TWC Guard is lowered.
Use lowest capacity transducer to cover the range of the torque wrench to be tested.
NOTE:
For a wrench with a push through ratchet, ensure the drive square is operating on the
correct side of the ratchet.
Ensure the transducer has been fitted with the correct adaptor and place the torque wrench drive into the
transducer. Ensure that the torque wrench drive is fully engaged (see Figure 15).
Set the reaction post position on the reaction arm so it is in the middle of the torque wrench handle (see Figure 16).
Use counter balance reaction (supplied) or optional short reaction post (Part number 60319) to suit wrench to be
tested.
Counter balance the wrench by adding weights to the carriage until the wrench is sat horizontally.
14
FIGURE 15 – Attaching a Torque Wrench
FIGURE 16 – Locating a Torque Wrench