Table of Contents
Advertisement
COMMISSIONING
Maximum Temperature Setting
Before using the shower the maximum temperature
must be checked to make sure that it is at a safe
level. It has been preset to a safe showering
temperature under ideal conditions at the factory,
appropriate for most systems. However, site
conditions and personal preference may make it
necessary to reset this temperature.
Note! Make sure that the hot water temperature is
at least 55°C and that there is sufficient supply.
Caution! Before testing the mixer, make sure
that the hot and cold water is flowing correctly by
exercising the temperature selector knob between
the cold and hot stops.
1. Turn the temperature selector knob to position
7 and test that the temperature of the water
from the shower outlet is hot enough.
2. If not, depress the override button and
carefully rotate towards position 9. If the water
temperature is still not hot enough complete
the following procedure.
3. Rotate the temperature selector knob back to
position 7.
4. Using a suitable screwdriver carefully prise
off the concealing cap and unscrew the fixing
screw.
5. Pull off the temperature selector knob without
disturbing the stop assembly.
Fixing Screw
6. Replace the temperature selector knob so that
the 6 mark is in line with the stop assembly.
7. Rotate the temperature selector knob to
position 7, wait for the water to stabilise and
test that the temperature of the water from the
shower outlet is hot enough.
If the water temperature is still not hot enough
repeat the procedure until a maximum safe
temperature is achieved at position 9.
8. Refit and tighten the fixing screw, refit the
concealing cap.
Temperature
Selector Knob
Concealing Cap
11
OPERATION
Adjusting the Temperature
The temperature is controlled by rotating the
temperature knob.
For safety reasons, the temperature is limited by
an override stop. To obtain a higher temperature,
press the override button on the temperature knob
and continue to rotate.
Decrease
Temperature
Adjusting the Flow
The flow is controlled by rotating the flow knob.
ON/Increase
Flow
Eco Setting
Operating the Divertor
The flow is switched between the fixed
showerhead, the showerhead and both together
by rotating the diverter knob.
Increase
Temperature
Temperature
Selector Knob
Eco
OFF/Decrease Flow
Hide quick links:
Advertisement
Table of Contents
