Set Up Instructions - sescom SES-X-FA2 User Manual

SES-X-FA2 AUDIO OVER SINGLE FIBER EXTENDER

Set Up Instructions

1. Secure the units in a safe location, where they will not be subject to impact and where there is room around the
unit so nothing will interfere with the fiber optic cabling causing it to bend sharply in a tight radius in any way that
can severely affect the signal transfer.
2. Use proper cable management and handling for routing fiber optic cable.
3. Carefully connect your source(s) to the transmitter input(s) and the receiver unit output(s) to your receiving device
input(s) using the XLR connectors on the transmitter and on the receiver unit.
4. Note that audio on the transmitter (Tx) can be Line or Mic level input and the receiver (Rx) is Line level only.
5. CLEAN* the ST fiber optical cable contacts that will be used for connecting the Tx and Rx units and attach the fiber
cable to the ST connections and secure, as you would secure a bayonet BNC. While pressing lightly in on the
connector, twist it in a clockwise direction about 1/8 to 1/4 of a turn and then release. The connector should stay
inserted and have backwards spring pressure holding the bayonet in place.
6. Connect the included power supplies to the transmitter and receiver units, and plug them both into an AC power
source (100-240VAC 50/60Hz) or insert the 9V batteries in both units for remote use.
* CLEAN: All fiber optical cable contacts require cleaning each time before inserting into a device's outputs or
inputs. Failure to clean the contacts can damage the unit's optics over time and also render the cable and the
device permanently useless.
Use cleaning kits designed specifically for fiber optics.
SESCOM SES-X-FA2 User Manual Ver 1a Page 4